Shop
- The product "Kit Solid State Speed Control 115V" has been removed from your wishlist because it can no longer be purchased.
- Failed to add “Kit Solid State Speed Control 115V” to your wishlist
-
$1,210.00BR130BR130 – Renewaire Energy Recovery Ventilator
- Typical Airflow Range: 50-140 cfm
- Optimally sized for the average residential home (up to 2700 sq. ft.)
- Simple & Efficient – Mounts directly to furnace (AC) return air ductwork, or to an exterior wall (with TW Kit) with just two duct connections
- Effective ventilation is ensured with integral automatic proportional runtime control
- 115V / 60 Hz / Single Phase corded plug
-
$870.00GR90GR90 – Renewaire Energy Recovery Ventilator
- Typical Airflow Range: 40-110 cfm
- Optimally sized for the small residential home, apartment or condominium ( up to 2000 sq. ft.), or small commercial project
- 120V / 60 Hz / Single Phase operation
- Galvanized Case, No Line Cord
- May be operated with any switched line voltage power supply
-
-
-
-
$260.00MC-CMotion (occupancy) Control – Ceiling Mount
- Motion Controller (Occupancy Sensor) – Ceiling Mount
- Passive Infrared Sensor
- Requires 24VAC power
-
$340.00MC-WMotion (occupancy) Control – Wall Mount
- Motion Controller (Occupancy Sensor) – Wall Mount
- Passive Infrared Sensor
- Requires 24VAC power
-
$210.00Motor and Capacitor – EV70/90/130/200, BR70/130
Part # 990140. This is an original replacement part for a Renewaire EV70, EV90, EV130 or PVS13 or EV200. The replacement part consists of the motor only. The blower section which includes the fan blades and fan housing is not included.
-
$140.00Motor and Capacitor – EV90/GR90/EV90P
Part # 990452. This is an original replacement part for a Renewaire EV90, EV90P, or GR90. The replacement part consists of the motor and the capacitor only. This unit takes (2) of these parts, one for the fresh air intake and the other for the exhaust air. To replace, you will need to disconnect the motor from the impeller. The wiring is done through a quick connect cable terminal. Just make sure that the unit is unplugged before attempting to replace the Impeller assembly.
-
$80.00PTLPercentage Timer (for use with EV Series)
- Percentage Timer Control
- Primary control for RenewAire Residential ERV Models EV90, EV90P, EV130, EV200 and EV300
-
$95.00FMPercentage Timer with Furnace Interlock (for use with EV Series)
- Percentage Timer Control with Furnace Interlock
- Primary control for RenewAire Residential ERV Models EV90, EV90P, EV130, EV200 and EV300 when Furnace Interlock is needed and PBL is not used
- Requires 24VAC power
-
$55.00PBTPush Button Boost Timer (for use with EV Premium Series)
- The Push Button Boost Timer (PBT) point-of-use control with indicator light is compatible with RenewAire Energy
Recovery Ventilator (ERV) models EV Premium and SL70. The PBT will operate your ERV for either 20, 40, or 60
minutes based upon how many times the logo button has been pushed. The indicator light on the front of the PBT
control is on whenever the ERV is operating, unless operating due to an additional control wired directly to your
ERV.
20-40-60 MINUTE VENTILATION CONTROL:
Press the logo and your ventilator will run for 20 minutes. Press again and the unit will run 40 minutes. A third
press provides for 60 minutes of operation.
You can cancel a cycle at anytime. Just press the logo for a fourth time.
You can start another cycle by pressing the logo.
- The Push Button Boost Timer (PBT) point-of-use control with indicator light is compatible with RenewAire Energy